equally all over, by a disk of light free from color.

The negative can then be replaced, and no further adjustment will be needed
for any further reproduction of the same size.

There is one point that requires attention: The lens used in the camera
should be a doublet of about 6 inch focus (in reproducing 8½ × 6½ or
smaller sizes), and the stop used must not be a very small one, not less
than ½ inch diameter. If a smaller stop is used, an even disk of light is
not obtained, but ample definition is obtainable with the size stop
mentioned.

In the arrangement described, a single lens is used for the condenser, not
because it is better than a double one, as is general for such purposes,
but because it is quite sufficient for the purpose. Of course, a large
condenser is both expensive and cumbersome. There is, therefore, no
advantage in using a combination if a single lens will answer.

In reproducing lantern pictures from half-plate negatives, the time
required on my lantern plates is from two to four minutes, using 6 inch
condenser. For whole plate negatives, from two to six minutes with a 9 inch
condenser. In working in this way it is easy to be developing one picture
while exposing another.

The condenser must be of such a size that it will cover the plate from
corner to corner. The best part of an 8½ × 6½ negative will be covered by a
9 inch condenser, and a 6½ × 4¾ by a 6 inch condenser.

With this arrangement it will be easy to reproduce from half or whole plate
negatives or any intermediate sizes quite independently of daylight.