_Softening and Softening Machines_. Two distinct courses are
followed in the preparation of the jute fibre after it leaves the
bale opener, and before it is carded by the breaker card. These
courses are designated as--

1. Hand Batching.
2. Machine Batching.

In the former process, which is not largely practised, the pieces of
jute are neatly doubled, while imparting a slight twist, to
facilitate subsequent handling, and laid in layers in large carts
which can be wheeled from place to place; if this method is not
convenient, the pieces are doubled similarly and deposited in large
stalls such as those illustrated in Fig. 10.

On the completion of each layer, or sometimes two layers, the
necessary measured amount of oil is evenly sprayed by hand over the
pieces from cans provided with suitable perforated outlets--usually
long tubes. After the oil has been added, water, from a similar
sprayer attached by tubing to a water tap, is added until the
attendant has applied what he or she considers is the proper quantity.
The ratio between a measured amount of oil and an unmeasured amount
of water is thus somewhat varied, and for this reason the above
method is not to be commended. A conscientious worker can, however,
with judgment, introduce satisfactory proportions which are, of
course, supplied by the person in charge. In Fig. 10, the tank on
the right is where the oil is stored, while the oil can, and the
spray-pipe and tube for water, are shown near the second post or
partition on the right.