although the latter may hold approximately 20 lbs. The machine must,
of course, deliver its quota to enable succeeding machines to be
kept in practically constant work. As a matter of fact, the machines
are arranged in what are termed "systems," so that this desirable
condition of a constant and sufficient feed to all may be
satisfactorily fulfilled.

The driving or pulley side of the breaker card is very similar to
that shown in Fig. 15 which, however, actually represents the pulley
side of one type of finisher card as made by Messrs. Douglas Fraser &
Sons, Ltd., Arbroath. All finisher cards are fed by slivers which
have been made as explained in connection with the breaker card, but
there are two distinct methods of feeding the slivers, or rather of
arranging the slivers at the feed side. In both cases, however, the
full width of the card is fed by slivers laid side by side, with,
however, a thin guide plate between each pair, and one at each
extreme end.

One very common method of feeding is to place 10 or 12 full sliver
cans--which have been prepared at the breaker card--on the floor and
to the right of the machine illustrated in Fig. 15. The sliver from
each can is then placed into the corresponding sliver guide, and
thus the full width of the machine is occupied. The slivers are
guided by the sliver guides on to an endless cloth or "feed sheet"
which, in turn, conveys them continuously between the feed rollers.
The feed apparatus in such machines is invariably of the roller type,
and sometimes it involves what is known as a "porcupine" roller. It
will be understood that the feeding of level slivers is a different
problem from that which necessitates the feeding of comparatively
uneven stricks.