* * * * *




IMPROVED GUN PRESSURE GAUGE.


The following description of the construction and mode of action is by
Thomas Shaw, M.E., Philadelphia, the inventor.

[Illustration: IMPROVED GUN PRESSURE GAUGE.]

Fig. 1 represents the gauge secured to small ordnance, the gun shown in
cross section. Fig. 2 represents face view of the gauge and indicator,
exposing a vertical section through the hydraulic portion of the gauge,
on line 3 and 4 of Fig. 1. The same principles of reduction of high
pressure are used in this gauge as in Shaw's hydraulic gauge. It will be
observed that a solid steel piston, E, in the cylinder, A, is provided
with a plunger on its under side, which comes in contact with an elastic
packing, D; the plunger may stand as 1 to A 1,000, or as 1 to A 100, in
point of area of exposed surface, as compared with the large piston head,
as desired. Assuming the proportions to be 1 to A 1,000, the 1,000 lb.
pressure on the plunger means only 1 lb. pressure in the fluid chamber,
above piston head, E, and this greatly reduced pressure is now
susceptible of measurement by any of the ordinary light pressure
instruments for measuring pressures. All the passage ways connecting to
dial gauge, R, with the fluid chamber above piston, E, are filled solid
with fluid, permitting no air spaces that can be avoided. The steel plug,