Use 80 ft. of 18-per-cent No. 22 gauge German-silver wire. Wind
the successive turns of wire so they will not touch each other and
fasten at each end with a turn or two of No. 16 gauge copper wire.
When this is complete have the helper hold the stretcher wires
while you tip the unfastened upright out and insert the wires of
the cage, then fasten the upright in place.

The wire from the binding-posts to the coil may be what is known
underwriters' wire or asbestos-covered wire No. 14 gauge, which is
held in place by double-headed tacks containing an insulation at
the head. These may be procured from electrical supply houses.
Connect the reinforced cord and terminals to the binding screws
and fasten the cover in place. This toaster will take four amperes
on 110-volt circuit.



** Cabinet for the Amateur's Workshop [37]

One of the most convenient adjuncts to an amateur's workbench is a
cabinet of some sort in which to keep nails, rivets, screws, etc.,
instead of leaving them scattered all about the bench. A very
easily made cabinet for this purpose is shown in the accompanying
illustration. The case may be made of 1/2-in. white pine or white
wood of a suitable size to hold the required number of drawers
which slide on strips of the same material, cut and dressed 1/2
in. square. The drawers are made of empty cigar boxes of uniform
size,

[Illustration: Empty Cigar Boxes Used for Drawers]