Off they all trooped to a little workshop back of the man's home. Soon
the boys were hard at work, sawing, whittling, and setting up type.

[Illustration: A sturdy dibber. This needs no directions for the making.
The cut tells the story.]

Here are directions for what the boys made.

DIRECTIONS FOR MAKING A COLDFRAME

Hemlock was the wood Jack used. The lumber for sides and ends is one
inch thick while strips marked A and B are one and one-fourth inches
thick. Cut out pieces 14 in. x 5 ft. 7 in., and 10 in. x 5 ft. 7 in.,
for the back and the front. Cut two pieces 14 x 36 in. and shape them
according to drawing for the ends. Nail these four pieces together to
form the frame. The sides should be nailed to the ends. Use ten-penny
nails and drive them slantingly.

[Illustration: WORKING SKETCH OF HOTBED

Jack's working drawing of his hotbed. This was to serve for a coldframe
temporarily.]

Saw out strips A two inches wide and as long as the slanting edge of the
end of the frame. Be careful with this measurement not to measure the
slanting edge of the _end_ piece only, but to include with it the
thickness of both front and back pieces. Saw out two more pieces two
inches wide and as long as the frame is wide at the bottom. Make strip B
2-1/2 in. x 5 ft. 7 in.