Keep the hands in the position above described; pass the shuttle at the
back, through the loop--that is, between the second and third fingers.
Take the end of the shuttle which comes out from the loop between the
forefinger and thumb of the right hand, and strain the cotton very
tightly towards the right. When the cotton is drawn through the loop,
this cotton must not be impeded by the fourth finger; it should, on the
contrary, slide over it, and be drawn tight. It should divide the loop
into two parts. After this withdraw the second left-hand finger, which
is _above_ the cotton, and pass it again under that cotton, so as to
draw up the loop. A _half-stitch_ is thus formed, and must be tightened
by being drawn closely to the forefinger and thumb of the left hand. For
the remaining half of the stitch keep the hands in the same position,
but, instead of letting the cotton fall over the thumb, pass this cotton
over the back of the hand; then let the shuttle fall between the second
and third fingers of the left hand, in front, and take it out again at
the back, strain the cotton very tightly, withdraw the second finger
from the loop, letting the cotton which is behind the hand sweep over
the fingers. When this is done, guide with the unoccupied fingers of the
left hand this second half-stitch up to the other, thus completing _one
stitch_.


_The Way to Make a Loop in Tatting._

When a certain number of stitches are made, very tightly draw in the
loop by straining the cotton until the first stitch touches the last,
and thus a loop is formed. During this process the stitches should be
held tightly between the forefinger and thumb.