divide by the diameter of the driven. (4 x 1500 = 6000; 6000 ÷ 20 =
300--revolutions of driven pulley.)


POINTS ON SETTING UP LATHE AND SHAFTING

The counter shaft should be about 7' above the lathe. A distance of 6'
from the center of the shaft to the center of the spindle is sufficient.
In setting a lathe or hanging a counter shaft it is necessary that both
be level. The counter shaft must be parallel to the line shaft. When the
counter shaft is in position a plumb bob should be hung from the counter
shaft cone to the spindle cone; the lathe should be adjusted so that the
belt will track between the two cone pulleys. The axis of the lathe must
be parallel to that of the counter shaft. The lathe, however, need not
be directly beneath the counter shaft as the belt will run on an angle
as well as perpendicular.




CHAPTER III

WOOD TURNING TOOLS


A wood turning kit should consist of one each of the following tools.
Fig. 2 shows the general shape of these tools.


1-1/4" Gouge