of time and trouble when you reach the camping ground. The best pegs
are made of iron or steel. This is especially true when the ground
where they are to be driven is hard or rocky, which is usually the
case. Steel tent pins may be bought for six cents apiece or possibly
the local blacksmith will make them for less. They should be a foot
long.

A sod cloth is a strip of canvas eight or ten inches wide fastened to
the bottom of the tent wall. Its purpose is to keep the wind and rain
from blowing under the tent. After the tent is pitched a ditch should
be dug all around it to catch the rain and carry it away. The earth
that is dug from this trench may be thrown on the sod cloth to hold it
down.

It is an excellent idea, if you are a beginner, to practise pitching
the tent at home so that you will understand it better when you are in
the woods. Besides this, you can try sleeping out a night or two to
see how you are going to like it.

[Illustration: A trapper's tent]

When you reach your camping place, the first step is to clear the
ground of all rubbish, loose stones, sticks and brush to have a clean
floor. Then unpack the tent and fit the pegs of the two upright poles
through the two holes in the ridge pole. Next raise the tent and peg
the guy ropes on the four corners first. A little practice will show
you how to do this. After all the ropes are pegged at a proper
distance from the tent, they should be tightened and the tent made
secure.