to be found in open woods--if not, some other kind will answer very
well. It should be about five or six feet in length, (trimmed of
its branches,) and in diameter need be no larger than an axe-handle
or a broom-stick. When this is decided, some spot about five feet
distant from the sapling should then be selected. The hatchet and
knife will now come into excellent use, in cutting the sticks for
the little inclosure shown
[Page 45]
in our drawing. This should be about eight or ten inches in diameter,
and of about the same height. The sticks should be driven into
the ground in a circle, leaving an open space of about six inches
on one side. A stout switch as large as a man's little finger,
and nearly two feet long, should then be cut and nicely sharpened
at both ends. This should then be driven into the ground in the
form of an arch, at the opening of the inclosure.

We will now ask our readers to turn their attention to the next
illustration, in order to understand what is to follow. This picture
shows the method of setting the trap.

[Illustration]

After the arch is firmly fixed in its place, a short piece of stick
should be cut, of a length corresponding to the height of the arch.
To the middle of this stick the bait should be attached, being
either tied to it or stuck on a plug driven into the stick, the
latter being sharpened on one end. Next proceed to cut another
stick, of about six inches in length; let this be flattened on
one end. The wire noose should then be fastened to the opposite
end. The noose in this case should be large enough to fill the