as he starts off into the woods. He will thus be supplied with parts
for thirty-three traps, all ready to be set, only requiring the
stakes for the pens, which may be easily cut in the woods. Having
selected a flexible sapling about five feet in length, and having
stripped it of its branches, proceed to adjust the pieces. Take one
of the upright sticks, and insert it firmly in the ground, with
its upper notch facing the sapling, and at about four feet distant
from it. Bend down the "springer," and by its force determine the
required length for the draw-string attaching one end to the tip
of the sapling, and the other near the end of a catch piece, the
latter having its bevelled side uppermost. The wire noose should
then be attached to the draw-string about six inches above the
catch-piece. The pen should now be constructed as previously directed.
Its entrance should be on the side _furthest_ from the springer,
and should be so built as that the peg in the ground shall be at
the back part of the enclosure. The pen being finished, the trap
may be set.

Insert the bait stick with bait attached into the square notch in
the side of the upright peg; or, if desired, it may be adjusted by
a pivot or nail through both sticks, as seen in our illustration,
always letting the baited end project toward the
[Page 50]
opening. Draw down the catch piece, and fit its ends into the notches
in the back of the upright peg and extremity of the bait-stick.
By now pulling the latter slightly, and gently withdrawing the
hand, the pieces will hold themselves together, only awaiting a
lift at the bait to dislodge them. Adjust the wire loop at the
opening of the pen, and you may leave the trap with the utmost
confidence in its ability to take care of itself, and any unlucky