"shuttle," although, strictly speaking, the Navajo has no shuttle. If
the figure to be woven is a long stripe, or one where the weft must be
passed through 6 inches or more of the shed at one time, the yarn is
wound on a slender twig or splinter, or shoved through on the end of
such a piece of wood; but where the pattern is intricate, and the weft
passes at each turn through only a few inches of the shed, the yarn is
wound into small skeins or balls and shoved through with the finger.

§ IV. The warp is thus constructed: A frame of four sticks is made,
not unlike the frame of the loom, but lying on or near the ground,
instead of standing erect. The two sticks forming the sides of the
frame are rough saplings or rails; the two forming the top and bottom
are smooth rounded poles--often the poles which afterwards serve as
the beams of the loom; these are placed parallel to one another, their
distance apart depending on the length of the projected blanket.

On these poles the warp is laid in a continuous string. It is first
firmly tied to one of the poles, which I will call No. 1 (Fig. 43);
then it is passed over the other pole, No. 2, brought back under No. 2
and over No. 1, forward again under No. 1 and over No. 2, and so on to
the end. Thus the first, third, fifth, &c., turns of the cord cross in
the middle the second, fourth, sixth, &c., forming a series of
elongated figures 8, as shown in the following diagram--

[Illustration: FIG. 43.--Diagram showing formation of warp.]

and making, in the very beginning of the process, the two sheds, which
are kept distinct throughout the whole work. When sufficient string
has been laid the end is tied to pole No. 2, and a rod is placed in
each shed to keep it open, the rods being afterwards tied together at