Scientific American Supplement, No. 1178, June 25, 1898 by Various
page 60 of 120 (50%)
page 60 of 120 (50%)
![]() | ![]() |
|
SELECTED FORMULÆ. REMOVAL OF INK FROM HECTOGRAPH.--It is recommended in Südd. Ap. Ztg. to pour crude hydrochloric acid upon the hectograph, rub with a wad of cotton, then wash off by holding under cold running water and drying with a cloth. The hectograph may be used again immediately. TO CLEAN WALL PAPER.--Four ounces of pumice stone in fine powder are thoroughly mixed with 1 quart of flour and the mass is kneaded with water enough to form a thick dough. This dough is formed into rolls about 2 inches in diameter and 6 or 8 inches long; each one is sewed up in a piece of cotton cloth and then boiled in water for from 40 to 50 minutes--long enough to render the dough firm. After cooling and allowing the rolls to stand for several hours, the outer portion is peeled off and they are then ready for use, the paper being rubbed with them as in the bread process.--Druggist's Circular. INSULATING COMPOUND.--Prof. Fessenden recommends for armature work a compound made by boiling pure linseed oil at about 200 degrees with 1/2 per cent. of borate of manganese, the boiling being continued for several hours, or until the oil begins to thicken. An advantage of this borated oil is that it always retains a slight stickiness, and so gives a good joint when wrapped around wires, etc. Many substances so used are not sticky and let moisture in through the joints. Where a smooth surface is required, it is readily obtained by dusting on a little talc. It can also be given a coat of japan on the outside.--American Electrician. |
|