The rear ends having been lashed in position, the arrow was set aside
to dry while the rest were prepared.

Five or ten having reached this stage and the binding being dry and
secure, he took one again between his left arm and chest, and with his
right hand drew all the feathers straight and taut, down the shaft.
Here he held them with the fingers of his left hand. Having marked a
similar place on each arrow where the sinew was to go, he cut the
bristles off the rib. At this point he started binding with another
piece of wet sinew. After a few turns he drew the feathers taut again
and cut them, leaving about a half inch of rib. This he bound down
completely to the arrow-shaft and finished all by smoothing the wet
lapping with his thumb nail.

The space between the rib and the wood he sometimes smeared with more
glue to cause the feather to adhere to the shaft, but this was not the
usual custom with him. After all was dry and firm, Ishi took the arrow
and beat it gently across his palm so that the feathers spread out
nicely.

As a rule the length of his feathers was four inches, though on
ceremonial arrows they often were as long as eight inches.

After drying, the feathers were cut with a sharp piece of obsidian,
using a straight stick as a guide and laying the arrow on a flat piece
of wood. When with us he trimmed them with scissors, making a straight
cut from the full width of the feather in back, to the height of a
quarter of an inch at the forward extremity. On his arrows he left the
natural curve of the feather at the nock, and while the rear binding
started an inch or more from the butt of the arrow, the feather drooped