fully in the detailed sectional elevation through the cylinder, showing
also the covers and jackets in section. The cylinder, made in four
pieces, is built up on Mr. W. Inglis's patent arrangement, with separate
liner and steam jacket casing and separate end valve chambers. This
arrangement simplifies the castings and secures good and sound ones. The
liner has face joints, which are carefully scraped up to bed truly to
the end valve chambers. The crosshead slides are each 3 feet 3 inches
long and I foot 3 inches wide. The engine was started last year, and
has worked beautifully from the first, without heating of bearings or
trouble of any kind, and it gives most uniform and steady turning. It is
worked now at forty-one revolutions per minute, or only 820 feet piston
speed, but will be worked regularly at the intended 900 feet piston
speed per minute when the spinning machinery is adapted for the increase
which the four extra revolutions per minute of the engine will give; the
load driven is over 1,000 horsepower, the steam pressure being 50 lb.
to 55 lb., which, however, will be increased when the existing boilers,
which are old, come to be replaced by new. Indicator diagrams from the
engines are given on page 309. The engine is very economical in steam
consumption, but no special trials or tests have been made with it. An
exactly similar engine, but of smaller size, with a cylinder 30 inches
diameter and 8 feet stroke, working at forty-five revolutions per
minute, made by Messrs. Hick, Hargreaves & Co. for Sir Titus Salt,
Sons & Co.'s mill at Saltaire, was tested about two years ago by Mr.
Fletcher, chief engineer of the Manchester Steam Users' Association, and
the results which are given below pretty fairly represent the results
obtained from this class of engine. Messrs. Hick, Hargreaves & Co. are
now constructing a single engine of the same type for 1,800 indicated
horse-power for a cotton mill at Bolton; and they have an order for a
pair of horizontal compound Corliss engines intended to indicate 3,000
horse-power. These engines will be the largest cotton mill engines in