diameter. It will pay you to be careful in selecting this box. Be
sure to have the cover. Score the wood deeply with a carpenter's
gauge inside and out 3-1/2 in. from the top of the box. With
repeated scoring the wood will be almost cut through or in shape
to finish the cut with a knife. Now you will have the box in two
pieces. The lower part, 8-1/2 in. deep over all, we will call the
basket, and the smaller part will be known as the tray.

Remove the band from the cover and cut the boards to fit in the
tray flush with the lower edge, to make the bottom. Fasten with
3/4-in brads. The kind of wood used in making these boxes cracks
easily and leaves a rough surface which should be well
sandpapered.

The four legs are each 3/4-in. square and 30-1/2 in. long. The
tops should be beveled to keep them from splintering at the edges.
With a string or tape measure, find the circumference of the tray
or basket and divide this into four equal parts, arranging the lap
seam on both to come midway between two of the marks. When
assembling, make these seams come between the two back legs.

The tray is placed 1-1/4 in. from the top end and the basket 6-3/4
in. from the bottom end of the legs. Notch the legs at the lower
point about 1/8 in. deep and 1-1/4 in. wide to receive the band at
the lower end of the basket. Fasten with 3/4-in. screws, using
four to each leg, three of which are in the basket. Insert the
screws from the inside of the box into the legs.

Stain the wood before putting in the