paper off with glass-paper (very finest), afterwards dusting the surface
to remove any trace of powder, and lay on a second coat of polish in the
same method. Then allow twenty-four hours to dry. Another light papering
may possibly be needed--dust off as before recommended and let the wood
have a _third_ coat of polish.

For this third coat a fresh rubber should be made, the inside being
sparingly supplied with spirits of wine instead of polish. Put a double
fold of linen over it, touch it with one drop of oil, and go very
lightly and speedily over the whole work.

In spiriting-off--the object of which is to remove any trace of smudge
that may blur the surface unless removed thus by spirit--you should go
gently to work, using a very light hand, or you may take the polish off
as well, amateurs more especially.


=Position.=--All work should be placed in an easy and accessible
position while it is being polished, so that the eye may readily
perceive the effect of the rubber; this will greatly help to relieve the
difficulties attending the polishing of a fine piece of furniture. It
should also be kept quite firm, so that it cannot possibly move about.
The most suitable benches for polishers are the ordinary cabinet-makers'
benches, with the tops covered with thick, soft cloths; these cloths
should not be fastened down, it being an advantage to be able to remove
them when required. When a piece of work too large to be placed upon the
bench is in hand, pads will be found useful to rest it upon. These can
be made by covering pieces of wood about two feet in length by three
inches in width with cloth several times doubled, the work being placed
so that a good light falls upon it. All thin panelling should be tacked